Table of Contents
Advertisement
General Information
Explanation of Technical Terms
Technical Term
Conveyor
DPI
Encoder
LED
Nozzle plate
Print direction
Print intensity
Print speed
Print start delay
Print width
Product sensor
Sensor
Shaft encoder
Seiko
Explanation
The conveyor transports the products, which should be
printed and pass them by the print head
Dots Per Inch
1 Inch = 25,4mm
See shaft encoder
Light emitting diode
On the nozzle plate are 500 nozzles arranged, which
ejected the ink.
Direction of movement of the product on the conveyor belt
viewed from the control system in the print direction
Contrast of the print image. If necessary this parameter
must be changed to optimize the print image.
intensity gives greater blackening and longer ink drying time
Print speed = Speed of the conveyor. The speed of the
conveyor must be keep constant
Offset print, i.e. by how much is printing delayed in
millimeters after the product is detected by the light barrier.
The number of pixel can be increased or decreased using
this parameter. The print image becomes narrower or
wider.
A sensor for the detection of the product. Mostly used are
optical sensors (photo sensor, light barrier, reflex sensor)
See Product-sensor
A shaft encoder is used for the automatic detection of the
conveyor speed and defines the print speed
Manufacturer of the print head module
Page 9 of 104
40075165 Markoprint integra PP108
A higher
GB
Advertisement
Table of Contents
