Table of Contents
Advertisement
Installation and Initial Operation
Installation
Only an optimally aligned installation of the system can ensure a continuous operation
with a low rate of failures and a minimum wear. For an optimized installation of the
system, fine tunings adapted to environmental conditions are essential. For the fine
tunings, a complex expert knowledge is required basing on experience with print
technique.
The complexity of a wear-optimized installation requires a high measure of specialized
knowledge and experience, which cannot be obtained completely by reading this
manual. Therefore the installation of the print system must be made by a technician from
your local distributor or examined by a final inspection. Damage or damages based on
an incorrect installation, represent no case of warranty.
Requirements to the Site of Installation
When choosing the installation location the following conditions apply:
Consider the generally accepted ergonomic criteria in accordance with workplace
ordinances as well as country-specific legislation.
The installation location must be a dry and dust-free room, ideally with an
ambient temperature of approx. 18...25 °C.
The installation location may not be subject to fast temperature fluctuations
(condensation!).
Do not set up the controller directly next to or above hot surfaces, since this will
affect cooling of the controller.
If the controller is operated on a tripod (accessory), the stability of the tripod on
an even foundation must be ensured.
The controller may not be exposed to flammable, explosive, corrosive gases or
chemical vapors.
The controller may not be installed in the vicinity of high voltage equipment or
power supplies.
The controller may not be subjected to direct vibrations or shocks.
Keep controller away from oil or water.
The controller may not be exposed to strong magnetic or electric fields.
Page 39 of 104
40075165 Markoprint integra PP108
GB
Advertisement
Table of Contents
