Table of Contents
Advertisement
Transport, Packaging and Storage
Storage
Controller
Store the controller incl. print head under the following conditions:
Do not store outdoors.
Keep dry and free of dust.
Do not expose to aggressive media.
Keep away from direct sunlight.
Avoid mechanical shock.
Storage temperature: 5°C to 40°C.
Air temperature gradient: < 10°C/hr
Relative humidity: 25 - 60%.
Storage print heads
Store the print heads under following conditions:
When a print head is stored or not used for more than six months, ink deposits may
form, which can result in the clogging of different nozzles.
In this case, fill the print head with fresh ink before using.
Procedure:
Leave the nozzle plate closed with the nozzle locking clamp!
Remove the feeder tube on the head and pump the old ink out of the ink supply
system
Then remove the return flow at the print head and pump the old ink out of the
print head
Finally, rinse out the head and resume operation.
Customers having replacement heads in storage should rotate these every three
months. In this way, the customer has a regular control over the functional integrity of his
print heads.
All print heads should be tested once before installation.
Before storage of the print heads the ink bottle must be taken out and stored according
the storage instructions given below ink bottles.
The print head must be closed with the nozzle clip and the vent cock of the ink system
must be closed. See also Disassembly of the print head.
Overlay
If the print head is stored for a longer period of time or not
used, different nozzles may become blocked.
Therefore:
– Fill the print head with new ink after 6 months at
the latest and before commissioning!
Page 27 of 104
40075165 Markoprint integra PP108
GB
Advertisement
Table of Contents
