Table of Contents
Advertisement
Operation
Operation
User interface of the print system
LED STATUS
GREEN: O.K.
Flashing: Standby
YELLOW: Printstop
Flashing: Read/Write USB-data transfer
RED: Failure print head not identified
Flashing: If the text selection is confirmed
by pressing the ON-/OFF-BUTTON
Flashing: Fast = USB failure
LED SENSOR
GREEN: Print
YELLOW: Photo sensor activation
without data
RED: No shaft encoder signal
Flashing: Shaft encoder too fast
OFF: No print signal
LED INK
GREEN: O.K.
YELLOW: Ink below 5%
Full rest container
RED: Ink empty
LED NETWORK
GREEN: Connected
YELLOW
Network activation
:
RED: Network failure
OFF: No network connected
LED STATUS, SENSOR and
INK
GREEN Flashing : Shut down
YELLOW Flashing: Shut down
When starting the system unit the progress of the starting process can be
monitored on the LED's. If errors occur during booting, an error code is
transmitted via the LED's and can be analyzed in more detail.
Chapter Boot-LED messages, page 92
Print start / Print stop
Text selection confirmation
>10 Sec. Standby-mode
ON-/OFF-BUTTON
+
INK-BUTTON
activate the purge process
Fig. 18: User interface at the top of the system
Page 56 of 104
40075165 Markoprint integra PP108
ON-/OFF-BUTTON
SELECTION-BUTTON
1 x short: Selection print image 1
2 x short: Selection print image 2
3 x short: Selection print image 3
...
9 x short: Selection print image 9
Confirm the text selection within 5 sec.by a
short pressing the ON-/OFF-BUTTON
Up to 9 print images can be saved. If more
often pressed than print images are in the
memory, the last print image in the memory
will be selected.
SELECTION-BUTTON
+ ON/OFF-BUTTON
increases the start delay +1mm
SELECTION-BUTTON
+ INK-BUTTON
decreases the start delay -1mm
INK-BUTTON
Short: Test print (The last loaded image will
be print once)
Long: (>5 sec.) Reset ink level
INK-BUTTON
+
ON-/OFF-BUTTON
activate the purge process
GB
Advertisement
Table of Contents
