Table of Contents
Advertisement
Safety Regulations
Remaining Risks
The print system is constructed for a safe operation. Hazards that are not preventable
due to construction purposes are limited as far as possible by protection devices. A
certain amount of risk is always existent! The knowledge about the remaining risks
assists you to arrange your work safer and to avoid incidents. In order to avoid the
dangers, please observe additionally the particular security advice in the single chapters.
Edges and corners pose risk of injury!
RISK OF INJURY!
Sharp edges and pointed corners may cause abrasions
and cuts to the skin.
Therefore:
–
Be cautious when working near sharp edges and
pointed corners.
–
If in doubt, wear protective gloves.
Risk of stumbling posed by dirt, objects lying about
and connecting lines!
RISK OF INJURY!
Dirt, objects lying about and connecting lines for power,
data- and signal lines may cause slipping and stumbling
resulting in severe injuries.
Therefore:
–
Always keep working area clean.
–
Remove objects no longer required.
–
Mark stumbling areas with yellow-black marking tape.
–
Non tension connecting lines to system and pass it
that no places of danger do arise
Page 15 of 104
40075165 Markoprint integra PP108
GB
Advertisement
Table of Contents
