Troubleshooting Tasks - Weber Markoprint integra PP108 Operating Manual

Faults

Troubleshooting tasks

Disorder Possible cause
The print head No power supply
does not print
at all
No start pulse
No print image is assigned
No shaft encoder signal
System
incorrectly
Start signal too early or late,
relative to the print object
Failure in the electronics of
the system or of the print
head
Fine gaps in Paper dust, other dust or
the print image fibers in the nozzle openings
followed by
satellite drops
Weak and Distance between print head
blurred print and object too large -
Print with false Check used and loaded fonts.
/too small
character
height
Shadow print Speed setting not correct
Troubleshooting
Check
power on switch
Check
connection (LED pulse)
Start print
Sensor LED is red. Check
shaft
connections
is configured Check
system configuration
Adjust
modification
parameter menu
Send print head in for repair
Run a purging cycle and wipe
the print head carefully clean.
If this is unsuccessful, send
the print head in for repair
Reduce distance to 1-3 mm
All fonts used in the text must
be loaded in the system –
IDESIGN Font Manager
Check
(intensity setting for rotary
encoder)
Page 80 of 104
40075165 Markoprint integra PP108
voltage input and Electrician
photo sensor Electrician
Instructed person
Electrician
encoder and
–
menu settings Instructed person
the corresponding Instructed person
in the print
Manufacturer
Electrician
Qualified person
Instructed person
speed setting Instructed person
Recovered by
GB