Table of Contents
Advertisement
Installation and Initial Operation
Connection to a network
A RJ-45-connection allows a connection of the print system to the customer LAN (Local
Aera Network).
The LED on the top of the system lights green if a network is available. The LED flashes
yellow with data communication.
The LED lights red if a failure exists.
Instruction
Please connect the print system with the network as follows:
Step
1
Fig. 12: Ethernet-socket (RJ 45) on the system-back and network LED on the top side of the
2
3
4
5
6
Each IP address can place in a network once only. Otherwise there is an address
conflict and the system can't address. Please contact your system administrator.
Procedure
If required connect the print system to the network via the RJ45 socket.
Connect the USB-stick to the Markoprint integra PP108 to write a system
image on the stick.
Connect the USB-stick to a PC with iDesign and set the desired free IP
address for the system by the iDesign software. (System settings – System
Config – IP-Address)
Add the system in the iDesign software to operate it by the iDesign software.
(Connections – Add system – Enter name and IP address)
Connect the USB-stick to the Markoprint integra PP108 again to adopt the
new settings.
The Markoprint integra PP108 is now displayed as Ethernet system in
iDesign.
Page 49 of 104
40075165 Markoprint integra PP108
system.
GB
Advertisement
Table of Contents
