Table of Contents
Advertisement
List of Accessories and Spare parts
HMI-Display (Human-Machine-Interface)
The print system can be extended by a display. With the HMI display, the current
settings can be edited and checked. The HMI display is connected to the 15-pin Sub-D
connector of the Markoprint integra PP108 by an adapter cable.
Via 4 status LEDs, various information of the system can be checked and changed.
The HMI display has a start and a stop button to start a print start or stop.
To use the HMI display, the HMI function must be enabled. Please contact your
local distributor.
Activate the HMI-Display
The HMI display can be activated via the local network or with an "initialized" USB stick.
Instruction
How to connect the HMI display with the print system
Conditions:
-
The device is switched on.
-
A PC with the current iDesign software is available.
-
The print system has firmware version 2020g or higher.
-
The HMI function has been activated by your responsible distributor.
Step
1
2
3
4
Procedure
Connect the 5-pin connector of the HMI display with the HMI connection
cable or the HMI Y-cable
Connect the 15-pin Sub D connector of the HMI connection cable or the 15-
pin Sub D connector of the Y-cable with the print system
Activate the HMI function via iDesign with the PC
Settings >> System >> Special settings >> Markoprint integra PP108 HMI
Now the system properties of the print system and the variables of the print
image can be changed and the print image can be selected via the HMI
display
Page 85 of 104
40075165 Markoprint integra PP108
GB
Advertisement
Table of Contents
