Connecting The Optional Shaft Encoder - Weber Markoprint integra PP108 Operating Manual

Installation and Initial Operation

Connecting the optional Shaft Encoder

If more options will be used simultaneously, a splitter-box (Art.-No.: 72900545) can
used.
Requirements

The optional shaft encoder is mounted at the production line.

Ideally runs the measuring wheel of the shaft encoder on the conveyor belt, near
the print system.
Instruction
Please connect the optional shaft encoder with the print system as follows:
Step
1
Fig. 10: Option-Socket (Sub-D 15-pole) on the system-back and Sensor-LED on the back side of
2
3
4
5
Procedure
If necessary install the optional shaft encoder on the production line and
connect it to the option-connection socket.
Set the system-clock to Shaft encoder by the iDesign software. (System
settings – Print parameter)
Set the shaft encoder resolution by the iDesign software. 600 dpi with the
delivered shaft encoder with friction wheel from Weber (600 dpi optimized).
(System settings – Print Parameter)
Set the intensity by the iDesign software so, that the desired effective
resolution can be reached (180 dpi is standard). (System settings – Print
parameter)
The Sensor / Encoder LED lights red, if the shaft encoder isn't connected or
doesn't rotate.
Page 47 of 104
40075165 Markoprint integra PP108
the system
GB