Table of Contents
Advertisement
Disassembly
Disassembly
When end of the useful life expires, the system must be disassembled and disposed in
an environmentally-friendly manner.
Staff
Disassembly may only be performed by specially trained specialized staff.
Work on the electrical system may only be performed by electricians.
Danger to life through electric shock!
DANGER TO LIFE!
Contact with live parts poses imminent danger to life.
Damaged insulation or individual components can be
lethal.
Therefore:
–
Immediately switch off the power supply and initiate
repairs if the insulation is damaged.
–
Work on the electrical system may only be performed
by electricians.
–
Before working on the electrical system, disconnect
from the mains (remove mains plug) and check that
power is off.
–
Always disconnect mains before performing cleaning
and repair tasks.
–
Keep moisture from live parts. Moisture may cause a
short-circuit.
Risk of injury caused by improper disassembly!
WARNING!
Stored residual energy, sharp-edged components, points
and corners on and inside the apparatus or on the
required tools may cause injuries.
Therefore:
–
Ensure adequate space before starting any work.
–
Handle exposed sharp-edged components with care.
–
Keep the work area clean and tidy! Loosely stacked
or scattered components and tools are potential
causes of accidents.
–
Secure components to prevent falling down or falling
over.
–
Consult the manufacturer if uncertain.
Page 81 of 104
40075165 Markoprint integra PP108
GB
Advertisement
Table of Contents
