Edit The Dial Plan On The Ip Phone; Reset The Control Timers - Cisco 7800 Series Administration Manual

Cisco IP Phone Installation

Edit the Dial Plan on the IP Phone

Note You can edit the dial plan in the XML configuration file. Locate the
configuration file, where n denotes the extension number. Edit the value of this parameter. The value must
be specified in the same format as in the Dial Plan field on the phone administration web page, described
below.
Before you begin
Access the phone administration web page. See
Procedure
Step 1
Select Voice > Ext(n), where n is an extension number.
Step 2 Scroll to the Dial Plan section.
Step 3
Enter the digit sequences in the Dial Plan field.
The default (US-based) systemwide dial plan appears automatically in the field.
Step 4 You can delete digit sequences, add digit sequences, or replace the entire dial plan with a new dial plan.
Separate each digit sequence with a pipe character, and enclose the entire set of digit sequences within
parentheses. Example:
(9,8<:1408>[2-9]xxxxxx | 9,8,1[2-9]xxxxxxxxx | 9,8,011xx. | 9,8,xx.|[1-8]xx)
Step 5
Click Submit All Changes.
The phone reboots.
Step 6 Verify that you can successfully complete a call with each digit sequence that you entered in the dial plan.
Note

Reset the Control Timers

If you need to edit a timer setting only for a particular digit sequence or type of call, you can edit the dial plan.
Before you begin
Access the phone administration web page. See
Procedure
Step 1 Select Voice > Regional.
Step 2
Scroll to the Control Timer Values (sec) section.
If you hear a reorder (fast busy) tone, review your entries and modify the dial plan appropriately.
Cisco IP Phone 7800 Series Multiplatform Phones Administration Guide
Dial_Plan_n_
Access the Phone Web Page, on page
Access the Phone Web Page, on page
Edit the Dial Plan on the IP Phone
parameter in the XML
80.
80.
69