Cisco 7800 Series Administration Manual page 244

VLAN Settings
Parameter
Syslog Identifier
Debug Level
Primary NTP Server
Secondary NTP Server
Enable SSLv3
VLAN Settings
Parameter
Enable VLAN
Cisco IP Phone 7800 Series Multiplatform Phones Administration Guide
230
Cisco IP Phone Troubleshooting
Description
Select the device identifier to include in syslog
messages that are uploaded to the syslog server. The
device identifier appears after the timestamp in each
message.
• None: No device identifier.
• $MA: The MAC address of the phone, expressed
as continuous lower case letters and digits.
Example:
c4b9cd811e29
• $MAU: The MAC address of the phone,
expressed as continuous upper case letters and
digits. Example:
C4B9CD811E29
• $MAC: The MAC address of the phone in the
standard colon-separated format. Example:
c4:b9:cd:81:1e:29
• $SN: The product serial number of the phone.
Default: None
Example XML configuration:
<Syslog_Identifier
ua="na">$MAC</Syslog_Identifier>
The debug level from 0 to 2. The higher the level, the
more debug information is generated. Zero (0) means
that no debug information is generated. To log SIP
messages, you must set the Debug Level to at least 2.
Default: 0
IP address or name of the primary NTP server used
to synchronize its time.
Default: Blank
IP address or name of the secondary NTP server used
to synchronize its time.
Default: Blank
Choose Yes to enable SSLv3. Choose No to disable.
Default: No
Description
Choose Yes to enable VLAN. Choose No to disable.