Digit Sequence Examples - Cisco 7800 Series Administration Manual

Digit Sequence Examples

Digit Sequence
<dialed:substituted>
, (comma)
! (exclamation point)
*xx
S0 or L0
P
Digit Sequence Examples
The following examples show digit sequences that you can enter in a dial plan.
In a complete dial plan entry, sequences are separated by a pipe character (|), and the entire set of sequences
is enclosed within parentheses:
Cisco IP Phone 7800 Series Multiplatform Phones Administration Guide
64
Function
This format indicates that certain dialed digits are replaced by the
substituted characters when the sequence is transmitted. The dialed
digits can be zero to 9. For example:
<8:1650>xxxxxxx
When the user presses followed by a seven-digit number, the system
8
automatically replaces the dialed
dials 85550112, the system transmits 16505550112.
If the dialed parameter is empty and there is a value in the substituted
field, no digits are replaced and the substituted value is always
prepended to the transmitted string. For example:
<:1>xxxxxxxxxx
When the user dials 9725550112, the number
beginning of the sequence; the system transmits 19725550112.
An intersequence tone played (and placed) between digits plays an
outside line dial tone. For example:
9, 1xxxxxxxxxx
An outside line dial tone plays after the user presses
continues until the user presses
Prohibits a dial sequence pattern. For example:
1900xxxxxxx!
Rejects any 11-digit sequence that begins with 1900.
Allows a user to enter a 2-digit star code.
For Interdigit Timer Master Override, enter
interdigit timer to 0 seconds, or enter
timer to 0 seconds.
To pause, enter , the number of seconds to pause, and a space. This
P
feature is typically used for implementation of a hotline and warm
line, with a 0 delay for the hot line, and a nonzero delay for a warm
line. For example:
P5
A pause of 5 seconds is introduced.
Cisco IP Phone Installation
with the sequence . If the user
8 1650
is added at the
1
. The tone
9
.
1
to reduce the short
S0
to reduce the long interdigit
L0