Table of Contents
Advertisement
Adjust the jack so that its claw surrounds
–
the jacking point on the door sill
- B underneath the stamp on the door sill.
Make sure that the base of the jack is en-
–
tirely supported on a flat surface and that it
›››
Fig. 126
is vertical
to the point where the
claw surrounds the jacking point on the
door sill.
Continue to wind up the jack using the
–
crank handle until the defective wheel is
clear off the ground.
Anti-theft wheel bolts*
Anti-theft wheel bolt with adapter.
Fig. 127
On vehicles fitted with anti-theft wheel bolts
(one bolt per wheel) these bolts can only be
loosened or tightened using a factory-sup-
plied adapter.
Pull off the hub cap or bolt cover.
–
154
Insert the adapter
–
›››
Fig. 126
toothed side as far as it will go on the inte-
rior toothing of the anti-theft wheel bolt
so that only the outer hexagonal is protrud-
ing.
Fit the box spanner as far as it will go over
–
adapter
.
B
Loosen or firmly tighten the wheel bolt
–
›››
page
152.
After removing the adapter, replace the hub
–
cap or the anti-theft wheel bolt cover.
Have the tightening torque of the wheel
–
bolts checked as soon as possible with a
torque wrench.
Note down the code number stamped on the
front of the adapter or on the front of the anti-
theft wheel bolt. You will need this number to
obtain a spare adapter from the SEAT original
accessories programme.
We recommend you always carry the wheel
bolt adapter in the vehicle. It should be stor-
ed in the vehicle tool kit.
Tyre repairs
TMS (Tyre Mobility System)*
The Tyre Mobility System is stored in a box
under the carpet in the boot.
Advice
›››
Fig. 127
with its
Using the Tyre Mobility System you can relia-
B
bly seal tyres damaged by foreign bodies,
provided that cuts or punctures are no larger
A
than approx. 4 mm in diameter. Do not re-
move the foreign bodies, e.g. bolts or nails,
from the tyre!
The tyre must be repaired immediately.
The repair made using the Tyre Mobility Sys-
tem under no circumstances replaces perma-
nent tyre repair and should only be used to
drive to the nearest official service.
The Tyre Mobility System kit shall not be
used:
●
●
-20 °C (-4 °F),
●
●
aged,
●
pressure or a completely flat tyre
●
expired
If the wheel rim has been damaged,
when the outside temperature is below
on slashes or punctures larger than 4 mm,
if the sidewall of the wheel has been dam-
If you have been driving with very low tyre
If the best-before date on the air can has
WARNING
Read and observe the safety warnings
Introduction on page
150.
A tyre filled with sealant does not have the
●
same performance properties as a conven-
tional tyre.
›››
in
Advertisement
Table of Contents
