Start-Stop* System - Seat Toledo 2015 Owner's Manual

Adjusting set speed
Increasing speed by pressing the accelerator
pedal
Press the accelerator to increase the speed
–
of the vehicle.
Release the accelerator and the previously
–
programmed speed will be resumed.
If, when pressing the accelerator, the vehicle
exceeds the programmed speed by more
than 10 km/h (6 mph) for more than 3 mi-
nutes, the set speed will be deleted. The
speed will have to be stored again.
Increasing speed by pressing switch
Press rocker switch
– B
›››
page 111 in RES.
If the button is held down in the RES posi-
–
tion, the speed increases continuously. Re-
lease the switch when the required speed
is reached. The speed is stored.
Setting a lower speed
The set speed can be reduced by pressing
–
››› ›››
switch Fig. 97
B
If the button is held down in the SET posi-
–
tion, the speed decreases continuously. Re-
lease the switch when the required speed
is reached. The speed is stored.
On releasing the switch at speeds of less
–
than 30 km/h (19 mph), no speed will be
112
set and the memory will be deleted. The ve-
hicle must be moving at a speed of over
30 km/h (19 mph) and switch
again to SET for it to be set.
The speed can be reduced by pressing the
brake pedal, which temporarily switches off
the cruise control.
Switching off cruise control
temporarily
Cruise control is switched off temporarily by
pressing switch
CANCEL or by pressing the brake or clutch
B
pedal.
›››
Fig. 97
The set speed is stored.
To recover the set speed, briefly press switch
in RES once you have released the brake
B
or clutch pedal.
Switching off cruise control
completely
page 111 in SET.
Move knob
–
OFF.
Operation
pressed
B
››› ›››
Fig. 97 page 111
in
A
››› ›››
Fig. 97 page 111
to
A

Start-Stop* System

Functioning
Instrument panel: Start-Stop system
Fig. 98
button
The Start-Stop system helps save fuel and re-
duce harmful and CO emissions.
2
The system is automatically switched on ev-
ery time the ignition is switched on.
The system automatically switches off the en-
gine when the vehicle is stationary, e.g. wait-
ing at traffic lights.
The current status of the Start-Stop system is
displayed on the general instrument panel
display.
Automatic engine shut down (Stop phase)
Stop the vehicle (if necessary using the
–
handbrake).
Shift to neutral.
–