Table of Contents
Advertisement
Placing the key slot cover.
Fig. 103
Remove the cap from the clamping bush
–
›››
Fig. 99
by pulling downwards.
Place the ball-headed bar in the service po-
–
›››
page
117.
sition
Hold the ball-headed bar from underneath
–
›››
Fig. 102
and push it into the clamping
bush as far as possible until you hear it
›››
click into place
.
The manual regulator
automatically turns
A
in the opposite direction, adjusting to the
›››
ball-headed bar
.
Switch off the manual regulator lock with
–
key
by turning the key fully to the right
B
in the direction of arrow
– the arrow in
1
the key displays the "locked" symbol.
Remove the key in the direction of arrow
–
.
2
Place cover
over the manual regulator
–
C
lock in the direction of arrow
Towing bracket device
Verify the correct placement of the ball-
–
headed bar
WARNING
●
Do not hold the manual regulator with your
hand when fitting the ball-headed bar since
you could sustain injuries to your fingers.
●
When mounting the ball-headed bar, al-
ways lock it with a key and remove the key
from the slot.
●
The ball-headed bar must not be in the
service position with the key in the key slot.
4
If the ball-headed bar is not placed in the
●
service position you will not be able to place
it in the clamping bush.
CAUTION
When removing the key, always place the
cover over the key slot of the manual regula-
tor to prevent dirt from entering.
Note
Once removed, place the clamping bush cap
in an appropriate location in the boot.
›››
Fig.
103.
3
›››
page
119.
Verification of correct placement
Correct placement of the ball-head-
Fig. 104
ed bar.
Before using the ball-headed bar, ensure it is
correctly fitted.
Ensure that:
●
The ball-headed bar does not come out of
the clamping bush in a "jerky" manner.
›››
●
The red mark
Fig. 104
on the manual
A
regulator signals toward the white mark on
the ball-headed bar.
The manual regulator is adjusted to the
●
ball-headed bar, leaving no space between
them.
●
The regulator is locked and the key has
been removed.
●
Cover
has been placed over the manual
B
regulator lock.
»
119
Advertisement
Table of Contents
