Changing The Wiper Blades - Seat Toledo 2015 Owner's Manual

Manual release of the selector lever
Manual release of the selector lever.
Fig. 135
If there is a fault in the power system to the
electronic selector lever lock system (flat bat-
tery, blown fuse) or the system itself is faulty,
the selector lever cannot be moved from po-
sition P in the normal manner, which pre-
vents the vehicle from being moved. The se-
lector lever must be unlocked using the man-
ual release.
Apply the handbrake.
–
Pull gently on both sides at the front of the
–
selector lever cover.
Also loosen the cover at the rear.
–
Press the yellow plastic part with your fin-
–
ger in the direction indicated by the arrow
›››
Fig. 135.
Press the interlock button on the selector
–
lever knob at the same time and move the
selector lever to position N (if the selector
162
Advice
lever is moved back to position P, it will
lock again).

Changing the wiper blades

Changing the windscreen wiper
blades
Windscreen wiper blades.
Fig. 136
Set the windscreen wiper arms to the service
position before changing the blades.
Service position for changing wiper blades
Close the bonnet.
–
Switch the ignition on and off.
–
Press the lever to position
–
4
›››
page 69, the windscreen wiper arms are
set to the service position.
Taking off the wiper blade
Lift the windscreen wiper arm away from
–
the glass moving the blade slightly in the
direction of the arm – arrow
Hold the top of the windscreen wiper arm
–
with one hand.
Unlock the catch
–
and remove the blade in the direction of ar-
row .
B
Fitting the wiper blade
Slide the blade fully until it clicks into posi-
–
tion.
Check that the wiper is correctly secured.
–
Fold the windscreen wiper arm back down
–
onto the glass.
Switch the ignition on and press the lever
–
to position
windscreen wiper arms are set to the basic
position.
›››
Fig. 56
›››
Fig. 136.
A
with the other hand
1
››› ›››
Fig. 56 page 69, the
4