Table of Contents
Advertisement
Service position.
Fig. 101
Before assembling, place the ball-headed bar
in service position.
Turn key
fully in the direction of arrow
–
A
›››
Fig.
100.
1
Hold the ball-headed bar with your left
–
hand.
Pull manual regulator
–
rection of arrow
and turn it fully in the
2
direction of arrow
.
3
118
The manual regulator will remain in this posi-
tion.
Service position
Key
●
row points to the "unlocked" symbol. The key
cannot be removed from the key slot.
●
The
into the body of the ball-headed bar by ap-
plying some pressure.
The red
●
tor points towards the white marking on the
ball-headed bar.
●
Between the manual regulator and the
body of the ball-headed bar there is a clearly
visible space of approximately 4 mm
Once the ball-headed bar has been posi-
tioned like this, it will be ready to be placed
in the clamping bush.
WARNING
Do not use the ball-headed bar if it cannot be
correctly placed in the service position.
CAUTION
The key cannot be removed from the manual
regulator key slot when it is in the service po-
outward in the di-
sition.
B
Operation
›››
Fig. 101
is in an open position – the key ar-
C
locking balls may be fully inserted
D
marking on the manual regula-
E
Assembling the ball-headed bar
.
F
Fig. 102
Placing the ball-headed bar/locking
and removing the key.
Advertisement
Table of Contents
