Table of Contents
Advertisement
›››
Fix the sticker
Fig. 128
–
2
onto the dash panel where the driver will
see it.
Do not remove the foreign body, e.g. bolts
–
or nails, from the tyre.
Unscrew the tyre valve cap.
–
Using the valve extractor
–
valve insert and place it on a clean surface
(cloth, paper, etc.)
Filling and inflating the tyre
Filling the tyre
Shake the tyre sealant can
–
›››
page 155
thoroughly several times.
Attach the flexible filling hose
–
can
. The foil sealing the can will be au-
10
tomatically pierced.
Remove the cap from the flexible filling
–
hose
and insert the open end as far as it
3
will go into the tyre valve.
Hold the can
upside down and fill the
–
10
complete contents of the can into the tyre.
Remove the empty can from the tyre.
–
Screw the valve insert back into the tyre
–
valve using the valve extractor
156
›››
Inflating the tyre
page 155
Screw the tyre filling hose
–
›››
page 155
Make sure that the bleed screw
–
closed.
Start the vehicle engine and leave it run-
–
ning.
, unscrew the
1
Plug connector
–
socket.
Turn on the air compressor with switch
–
Leave the air compressor running until the
–
tyre pressure has reached 2.0 -2.5 bar
(29-36 psi/200-250 kPa). The max. operat-
›››
ing time for the compressor is 8 minutes
Fig. 128
10
›››
!
Switch the compressor off.
–
onto the
3
When an air pressure of 2.0-2.5 bar
–
(29-36 psi/200-250 kPa) cannot be
reached, unscrew the flexible tube
the tyre valve.
Drive the vehicle approx. 10 metres for-
–
wards or backwards, so that the sealant
can "spread evenly" in the tyre.
Screw the flexible hose from the air com-
–
pressor
peat the inflation process.
.
1
If the pressure is still lower than specified,
–
the tyre is too badly damaged. The tyre can-
Advice
›››
Fig. 128
5
firmly onto the tyre valve.
is
7
into the 12-volt power
9
from
5
back onto the tyre valve and re-
5
not be repaired using the tyre sealant kit
›››
.
Switch the compressor off.
–
Unscrew the flexible hose
–
valve.
When a tyre pressure of 2.0-2.5 bar
(29-36 psi/200-250 kPa) is reached, you can
continue driving at a max. speed of 80 km/h
(50 mph).
Check the tyre pressure after 10 minutes of
.
8
›››
driving
page
157.
WARNING
The flexible tyre filling hose and the air
●
compressor may heat up during the filling
process. Risk of injury!
Do not place the hot flexible tyre filling
●
hose or hot air compressor on top of flamma-
ble materials. Risk of fire!
If the tyre cannot be inflated to a minimum
●
pressure of 2.0 bar (29 psi/200 kPa), then
the tyre is too badly damaged. The sealing
product is unable to seal the tyre . Do not
continue driving and obtain professional as-
sistance.
CAUTION
Do not use the air compressor for longer than
8 minutes at a time. Risk of overheating! Be-
fore using the air compressor again, leave it
to cool down for several minutes.
from the tyre
5
Advertisement
Table of Contents
