Table of Contents
Advertisement
Take the screwdriver or a Torx 20 key (T20)
–
from the vehicle tool kit and loosen (turn-
ing anti-clockwise) and remove the two re-
taining screws that secure the front of the
›››
light
Fig. 153
, taking care not to lose
1
them.
Pull the rear light unit backward
–
›››
Fig. 153
(
) to remove the light from its
2
housing.
Remove the bulb holder
Light connector at the rear of the
Fig. 154
rear light unit.
170
Advice
Retaining screws on reverse side of
Fig. 155
rear light unit.
Disconnect the light connector
–
›››
Fig. 154
by moving its side levers (ar-
rows) and pulling the connector outwards.
Place the light on a level, horizontal surface
–
on top of a soft cloth so as not to scratch
the outer glass.
Unscrew the four retaining screws from the
–
bulb holder anti-clockwise using a screw-
driver or a Torx 20 key (T20) from the vehi-
›››
cle tool kit
Fig.
155. Take care not to lose
the bulb holder retaining screws.
Changing bulbs
Fig. 156
Position of the bulbs in the bulb
A
holder
The bulbs are secured with a bayonet fasten-
er. The table below gives an overview of the
bulb positions.
Lightly press the defective bulb into the
–
bulb holder, then turn it anti-clockwise and
remove it.
Fit the new bulb, pressing it into the bulb
–
holder and turn it clockwise as far as it will
go.
Use a cloth to remove any fingerprints from
–
the glass part of the bulb.
Check that the new bulb works properly.
–
Replace the bulb holder.
–
Screw in the bulb holder using the four
–
screws, turning them clockwise.
Advertisement
Table of Contents
