Section 4: Electrical interface
7. Ethernet wiring
Default IP address from factory:
48
Ethernet interface can be used to power the MorphoAccess
through POE (Power Over Ethernet) mode. According to the POE standard two
modes are available: power on data pins and power on dedicated pins.
®
On MorphoAccess
J Series terminal, POE can be used with RJ45 connector
or with block connector. Modes are implemented as follows:
•
POE through RJ45 connector: on data pins or on dedicated pins.
•
POE through block connector: on data pins.
Use either one of these modes depending on POE implementation on your local
Ethernet network.
GND
Ground for Ethernet Interface (LAN 10/100 Mbps)
RX-
Receive negative Ethernet
RX+
Receive positive Ethernet
TX -
Transmit negative Ethernet
TX+
Transmit positive Ethernet
134.1.32.214
M
ORPHO
®
MorphoAccess
J Series – Installation Guide
DOCUMENT SSE-0000077503-04 - M
D
- R
OCUMENT
EPRODUCTION AND DISCLOSURE PROHIBITED
®
J Series terminal
2011
ARCH