Safran MorphoAccess J Series Installation Manual page 26

®
Section 3: Installation procedure MorphoAccess J Series – Installation Guide
.
Figure 3.1: Drilling template
4.Wire the necessary cables on the block connectors according to Section 4;
then plug the block connectors into the terminal blocks (6 on Figure 2.3).
5. Plug Ethernet cable (if present) into the RJ45 connector (5 on Figure 2.3).
6. Bring the terminal's body close to the wall, with the terminal's mounting
holes (2 on Figure 2.3) facing the 2 holes drilled into the wall.
7. Fix the terminal's body to the wall with the 2 M3X25 screws (see Figure 3.2).
Pay attention not to damage the biometric module with the screwdriver when
accessing the mounting hole located at the bottom of the terminal.
Figure 3.2: Terminal's body fixing
18 DOCUMENT SSE-0000077503-04 - M 2011
ARCH
M D - R
ORPHO OCUMENT EPRODUCTION AND DISCLOSURE PROHIBITED