®
MorphoAccess
J Series – Installation Guide
2. Installation on a standard electric
box (example of the European
electric box)
Required tools (not supplied)
Equipment from the initial package to use
Step by step procedure
DOCUMENT SSE-0000077503-04 - M
M
D
- R
ORPHO
OCUMENT
EPRODUCTION AND DISCLOSURE PROHIBITED
•
One (1) Philips head screw driver
•
One (1) Flat tip screw driver (for screws of the electric box that are not
supplied with the product)
•
One (1) Drill (with a Ø 5mm drill bit)
•
One (1) Flat tip screw driver (diameter 2,5mm) for block connectors screws
•
One (1) Terminal's body
•
One (1) Smoked front cover
•
Two (2) Block connectors
•
One (1) M3X25 screw
•
One (1) Rawplug (for Ø 3mm screws)
•
Two (2) M2.5X14 screws
•
Two (2) Screw rubber caps
•
One (1) L-shaped Torx screw driver
Power supply from electrical source shall be switched off before starting the
installation.
1. Confirm the presence of the electric box in the wall or add it if not present .
Remove the two horizontal screws from the electric box (see Figure 3.6): these
screws will be used for terminal's body fixation; if not present they can be
replaced by two M3X25 screws supplied in the package.
2. Confirm the presence of all the cables needed for the electrical installation
(see Section 4).
2011
ARCH
Section 3: Installation procedure
21