Safran MorphoAccess J Series Installation Manual page 40

®
Section 3: Installation procedure MorphoAccess J Series – Installation Guide
5. Connect the USB cable to the Wi-Fi™ dongle and install them inside the
mounting spacer (see Figure 3.20).
Figure 3.20: Wi-Fi™ dongle installation
6. Wire the necessary cables on the block connectors according to Section 4;
then plug the block connectors into the terminal blocks (6 on Figure 2.3).
7. Plug the USB cable into the terminal's mini-USB port (4 on Figure 2.3).
8. Bring the terminal's body close to the mounting spacer, with the terminal's
mounting holes (2 on Figure 2.3) facing the screw bosses on the mounting
spacer.
9. Fix the terminal's body to the mounting spacer with the 2 M3X25 screws
(see Figure 3.21).
Pay attention not to damage the biometric module with the screwdriver when
accessing the mounting hole located at the bottom of the terminal.
32 DOCUMENT SSE-0000077503-04 - M 2011
ARCH
M D - R
ORPHO OCUMENT EPRODUCTION AND DISCLOSURE PROHIBITED