Safran MorphoAccess J Series Installation Manual page 34

®
Section 3: Installation procedure MorphoAccess J Series – Installation Guide
Figure 3.10: Four fixing holes layout
3. Bring the mounting spacer close to the wall, with its mounting holes facing
the holes drilled into the wall.
4. Fix the mounting spacer to the wall with the four 3mm diameter screws (not
supplied; see Figure 3.11).
Figure 3.11: Mounting spacer fixing
5. Wire the necessary cables on the block connectors according to Section 4;
then plug the block connectors into the terminal blocks (6 on Figure 2.3).
The Ethernet connection can only be done on terminal block in this
configuration (RJ45 can't be used).
26 DOCUMENT SSE-0000077503-04 - M 2011
ARCH
M D - R
ORPHO OCUMENT EPRODUCTION AND DISCLOSURE PROHIBITED