Safran MorphoAccess J Series Installation Manual page 35

®
MorphoAccess J Series – Installation Guide
DOCUMENT SSE-0000077503-04 - M
M D - R
ORPHO OCUMENT EPRODUCTION AND DISCLOSURE PROHIBITED
6. Bring the terminal's body close to the mounting spacer, with the terminal's
mounting holes (2 on Figure 2.3) facing the screw bosses on the mounting
spacer.
7. Fix the terminal's body to the mounting spacer with the 4 M3X25 screws (see
Figure 3.12).
Pay attention not to damage the biometric module with the screwdriver when
accessing the mounting hole located at the bottom of the terminal.
Figure 3.12: Terminal's body fixing
8. Switch on power supply from electrical source and confirm that the terminal
switches on (checking light from LED indicator and sound from buzzer).
9. At this stage, a USB mass storage key can be plugged into the terminal for
configuration (see Figure 3.13). For more details about product configuration
and setting, refer to MorphoAccess
is completed, remove the USB mass storage key.
Figure 3.13: USB mass storage key plugging
10. Plug the smoked front cover onto the terminal's body, plugging first the top
part and then the bottom part (see Figure 3.14).
Apply pressure on the whole surface of the smoked front cover to make sure it
is correctly plugged. This is necessary to activate the anti-tamper switches and
ensure watertightness.
2011
ARCH
Section 3: Installation procedure
®
J Series User Guide. Once configuration
27