Table of Contents
Advertisement
How This Manual is Organized
This manual consists of 1 chapter and 2 appendices as follows.
Chapter 1
Describes a suitable location for your laser printer and how to unpack and install it. Be sure to read this chap-
ter before setting up the printer.
Chapter 2
Explains procedures to isolate and solve problems that may occur during the installation of your printer.
Control panel LCD error messages are also discussed in this chapter.
Appendix A
Provides information on how to contact GENICOM Corp. for technical support, service and repair issues.
Appendix B
Describes cautions to take when installing, transporting, or operating the printer. Also includes applicable
regulatory compliances of your printer.
Manual Conventions
NOTE:
Notes contain tips, extra information, or important information that deserves emphasis or
reiteration.
Caution: Cautions present information that you need to know to avoid equipment damage, process
failure, or extreme annoyance. Pay special attention to these sections and read them fully before
operating the printer. GENICOM will not be responsible for any problems or damage arising from
improper use.
WARNING! Warnings indicate the possibility of personal injury if a specific procedure is not per-
formed exactly as described in the manual. Pay special attention to these sections and read them fully
to prevent possible injury.
Jun 99
Unpacking and Installing Your Printer
Troubleshooting
GENICOM Customer Support
Safety Notes and Regulatory Compliances
microLaser 320 and 401 Installation Guide
Chapter 1 Unpacking and Installing Your Printer
u
u
u
Genicom
5
Publication No. GEK-89496C
Advertisement
Table of Contents
Troubleshooting
