Turning The Printer On - Genicom microLaser 320 Installation Manual

Turning the Printer On

Set the power switch to the [I] position to turn on the printer.
The top line of the LCD display reads:
followed by asterisks progressing across the bottom line:
Following a LED self test, asterisks progress across both lines of the display
and the Power On Self Test ends with the top line of the display reading:
NOTE: While turned on, the printer will go into the standby state if it remains idle for a period of time.If an
error message appears, see "Control Panel LCD Messages" on page 8-20 in the
401
Jun 99
Loading
**************
**************
**************
Ready
User's Guide located on the
microLaser 320 and 401 Installation Guide
GENICOM Electronic Library for Non-impact Printers
Genicom
For standard configuration
microLaser 320 and
CD-ROM.
Publication No. GEK-89496C
1-19