Setting The Delay Time - Siemens SIMATIC HMI Mobile Panel 277 RO Operating Instructions Manual

6.6

Setting the delay time

Introduction
After switching on the HMI device, the RemoteOperate Client application starts after a delay
time. The Loader is displayed during the delay time.
Requirements
You have opened the "Transfer Settings" dialog box, "Directories" tab, by touching the
"Transfer"
①
②
③
④
Note
Settings under "Path"
Do not change the settings in the "Path" field. If changes are made here, the RemoteOperate
Client software may not start the next time the HMI device is switched on.
Procedure for setting the delay time
1. Select the desired delay time in seconds in the "Wait [sec]" selection box.
With the value "0", RemoteOperate Client starts immediately. It is then no longer possible
to call the Loader after switching on the HMI device. Set a value greater than "0" if you
need to access the loader.
2. Confirm your entries.
The dialog closes.
Result
The delay time for the HMI device is now set.
Mobile Panel 277 RO
Operating Instructions, 10/2015, A5E36824256-AA
icon.
Location of the project file. Not relevant for the Mobile Panel 277 RO.
Directory where the compressed source file of your project is saved
Not relevant for the Mobile Panel 277 RO.
Location and start file for RemoteOperate Client
Selection box for the delay time
Configuring the operating system
6.6 Setting the delay time
95