Siemens SIMATIC HMI Mobile Panel 277 RO Operating Instructions Manual page 103

Procedure
Proceed as follows:
1. Select "BACKUP" to start Backup.
2. The HMI device checks the memory card.
If no memory card is inserted in the card slot of the HMI device or if the memory card is
damaged:
– The following warning is displayed:
– Acknowledge the warning and the following message "Backup aborted".
A message is displayed if the memory card already contains data. Follow the instructions
of the HMI device.
3. The following messages and dialogs are displayed in sequence during backup:
– "Checking Registry"
– "Backup Progress"
– "Saving CE-Image"
A progress bar shows the status of the backup process.
4. If backup was successful, the following message is displayed:
"Backup successfully completed. Press OK and remove your storage card."
5. Click "OK" button to acknowledge the message.
Remove the memory card.
Result
The HMI device data is now saved on the memory card.
Mobile Panel 277 RO
Operating Instructions, 10/2015, A5E36824256-AA
"No storage card detected!"
The Control Panel is displayed again.
Configuring the operating system
6.9 Backup and restore with the memory card
103