Escape Operation - Canon XJ22 7.3B Series Operator's Manual

Escape operation

This operation makes it possible to jump from the current setting status of the user (any user from 0 to 9) to the user 0
setting status (factory setting status) in an instant.
※ (NOTE): The jump operation cannot be performed in the lock status.
※ (NOTE): Even when the jump operation is performed, the settings of the following items will remain the same
as before the jump operation: auto iris gain value, remote iris gain value, F-Hold setting, encoder
output setting, IND screen follow-up display settings,default screen settings,Switchable setting and
Adjustment of Camera Fol Voltage.
Any screen
[ ]
1
Menu
[ IND ] I G : 5 0
EXT VTR
A 1 V
FRM1 RET
A 2 R
Top initial screen
[ ]
Menu 0
[ IND ] I G : 5 0
EXT VTR
A 1 V
FRM1 RET
A 2 R
When the power is turned on again:
The same user who was using the system prior to the jump operation is selected. However, if the user was
changed after the jump operation was performed, the user using the system after the change was made is
selected instead.
[ ]
and
DISPLAY Set
1. Hold down the DISPLAY switch and Set key for more than 2 seconds.
The following message is displayed depending on the user who was using the system prior to
the jump operation.
User 0: User 0 Reset Now
User 1 to 9: Escape To User 0
With User 0
User 0
Reset Now
2. The Top initial screen is displayed.
2sec
With User 1 to 9
Escape To User 0
or
User – Escape operation
4. Menu screen – User
E4-19