Copying Data Between Lenses; Copying The Data Settings Established For One User Into Another Lens - Canon XJ22 7.3B Series Operator's Manual

4. Menu screen – User

Copying data between lenses

The setting established on the information display can be copied into another information display drive unit.
There are two copy types.1:Copying the data settings established for one user ( See this page). 2:Copying the data
settings established for all the users ( See the page E4-12).A dedicated cable purchased separately is required for this
operation. For further details,consult a Canon sales representative or your Canon dealer.

(1) Copying the data settings established for one user into another lens

Preparations prior to operation (Be absolutely sure to undertake these preparations.)
1. Plug one end of the dedicated cable (20P-20P) into the zoom remote & focus remote connector (20-pin) of
the copy source lens and the other end into the corresponding connector of the copy destination lens.
2. Turn on the power of the copy source lens and copy destination lens.
3. Push the DISPLAY switch on the copy source lens to turn on the display. (Do not turn on the display of the
copy destination lens.)
IMPORTANT:
Top initial screen
[ ] 1
Menu
[ IND ] I G : 5 0
EXT VTR
A 1 V
FRM1 RET
A 2 R
User screen
1
User
No. : 1
Name:
ResetAll
Screen A
1
User
Copy
ToOtherLens
Access: Unlock
ToOtherLens screen
1
User
ToOtherLens
Connect: y/n
1
User
ToOtherLens
Connect: y/n
1
User
ToOtherLens
Connect: y/n
Screen B
1
User
ToOtherLens
UserCopy : y/n
AllCopy : y/n
E4-10
User – Copying data between lenses
Prior to operation, select the user for whom the settings will be made.
(For details on how to select the user, refer to page E3-4 or E4-4.)
1. Push the
The display is switched to the User screen.
2. Push the
An underline appears below [ToOtherLens].
3. Push the Set key.
The display is switched to the ToOtherLens
screen.
4. Push the
An underline appears below [Connect], and
either {y} (YES) or {n} (NO) can now been
selected.
5. Push the
6. Push the Set key.
The display is switched to the screen B.
7. Push the
key, and push the Set key.
key five times.
key.
key, and select {y}.
key.
The operating steps taken be-
tween steps 1 to 12 (within the
two dotted parallel lines) can be
undone without copying the set-
tings. To return to the original
screen, push the up key. To
turn off the display without
copying the settings, push the
DISPLAY switch.
Continued on next page