Setting The Servo Type From The Zoom Demand - Canon XJ22 7.3B Series Operator's Manual

4. Menu screen – Zoom

Setting the servo type from the zoom demand

Either the speed servo or position servo can be set as the servo type from the zoom demand.
IMPORTANT:
Top initial screen
[ ] 1
Menu
[ IND ] I G : 5 0
EXT VTR
A 1 V
FRM1 RET
A 2 R
Zoom screen
[ ]
Zoom
Tracking: OFF
F-Hold: OFF
Movement
[ ]
Zoom
Movement
CurveMode
Control: Sped
[ ]
Zoom
Movement
CurveMode
Control: Posi
※ (NOTE): When {Posi} has been selected, only one demand connector can be connected.
Normally, {Sped} is selected.
(D)
Selection item
Function Speed servo
(D): Default value
Menu
E4-50
Zoom – Setting the servo type from the zoom demand
Prior to operation, select the user for whom the setting will be made.
(For details on how to select the user, refer to page E3-4 or E4-4.)
1. Push the
The display is switched to the Zoom screen.
2. Push the
An underline appears below [Control].
The function set last or default function is highlighted.
3. Push the
Push the left or right key to select {Sped} or {Posi}.
Sped Posi
Position servo
Set x4
key, push the key and push the
Set
key five times.
key or key.
[ ]
Zoom
key four times.
x5 or