Setting The Zoom Speed In The Preset Mode - Canon XJ22 7.3B Series Operator's Manual

4. Menu screen – Preset

Setting the zoom speed in the preset mode

The zoom speed from any position up to the memory position can be set. There are two ways to change the speed
setting: one involves using the Memo button (refer to the Lens Operation Manual), and the other is through display op-
erations. Either way can be used, but the setting established last takes precedence.
IMPORTANT:
※ (NOTE): The same setting value applies to both Frame1 and Frame2.
Top initial screen
[ ] 1
Menu
[ IND ] I G : 5 0
EXT VTR
A 1 V
FRM1 RET
A 2 R
Preset screen
Preset
Frame1: PRE
Frame2: PRE
ZSpeed: 800
Preset
Frame2: PRE
ZSpeed: 800
ZMovement
Preset
Frame2: PRE
ZSpeed: 500
ZMovement
Selection item
Function Minimum speed
Menu
E4-34
Preset – Setting the zoom speed in the preset mode
Prior to operation, select the user for whom the setting will be made.
(For details on how to select the user, refer to page E3-4 or E4-4.)
1. Push the
The display is switched to the Preset screen.
2. Push the
An underline appears below [ZSpeed].
The last setting or default value is highlighted.
3. Push the
Push the left or right key until the number to be
changed to appears.
(D)
001 to 800
Maximum speed
(D): Default value
x2
Set
key, push the Set key, and push the
key three times.
key or key.
Preset
key twice.
x3 or