Setting The Remote Iris Gain - Canon XJ22 7.3B Series Operator's Manual

(2) Setting the remote iris gain

The remote iris gain has already been set to level "90" at the factory but it can be changed if so desired.
The same remote iris gain setting is used for all the users regardless of the user who is indicated on the display. For
this reason, there is no need to select the user before performing the setting. As an exception to the general rule, any
change made in the setting is reflected for user 0 as well.
Top initial screen
[ ] 1
Menu
[ IND ] I G : 5 0
EXT VTR
A 1 V
FRM1 RET
A 2 R
Iris screen
[ ]
Iris
[ I-Gain ]
Comp: ON
Close: OFF
[I-Gain] screen
[ ]
Iris
[ I-Gain ]
Auto: 50
Remote: 90
[ ]
Iris
[ I-Gain ]
Auto: 50
Remote: 90
[ ]
Iris
[ I-Gain ]
Auto: 52
Remote: 95
[ ]
Iris
[ I-Gain ]
Comp: ON
Close: OFF
Selection item
Function
Minimum gain
Default value: 90
Menu Set
1. Push the
push the
The display is switched to the Iris screen.
2. Push the
The display is switched to the [I-Gain] screen.
3. Push the
An underline appears below [Remote].
The function set last or default value is highlighted.
4. Push the
Push the left or right key until the value to be
changed to appears.
5. Push the
01 to 99
Maximum gain
x3 Iris
key, push the key and
Set
key three times.
key, and push the
Set
key twice.
key or key.
key.
Set
[ ]
Set
※ (NOTE): When adjusting the
gain while checking
the iris operation
→ Set the camera's iris
mode to [Remote].
key.
※ (NOTE): The iris gain setting
is not initialized
even when the
steps described in
"Initializing" on page
E4-6 are taken.
x2 or
Iris – Setting the remote iris gain
4. Menu screen – Iris
Set
E4-39