When An Error Display Has Appeared - Canon XJ22 7.3B Series Operator's Manual

4. Menu screen – User

(3) When an error display has appeared

If the settings were not copied successfully between the lenses, refer to the information in the table below.
Error screen
Lens Connect
Error!!
Copy Error!!
E4-14
User – Copying data between lenses
Checkpoint
Has the dedicated Data cannot be copied between the
cable (20P-20P) been lenses unless the dedicated cable
connected? (20P-20P) has been connected.
Has the power of the Data cannot be copied between the
copy destination lens lenses unless the power of both the
copy source lens and copy destination
been turned on?
lens has been turned on.
Has the dedicated
If, during copying, the cable
cable (20P-20P) been
was disconnected or the power
connected?
of the copy destination lens
dropped or it was turned off, the
screen with the message shown
on the left will be displayed.
In a case like this, data copying has
Have the power of both
been stopped before it was completed
the copy source lens
and, as a result, the data is not copied
and copy destination
properly.
lens been turned on?
Cause of error Remedial action
Securely connect the dedicated cable
(20P-20P) to the copy source lens and
copy destination lens, and go through
the copying procedure again from the
start.
Turn on the power of both the copy
source lens and copy destination lens,
and go through the copying procedure
again from the start.
Check that the power of both the copy
source lens and copy destination
lens have been turned on and the
dedicated cable has been connected
securely. Then push the DISPLAY
sw and the display is switched to the
Screen A, and go through the copying
procedure again from the start.
Screen A
User 1
Copy
ToOtherLens
Access: Unlock