Zoom Curve Mode Setting - Canon XJ22 7.3B Series Operator's Manual

3. Top screen
[ Z.M. ]

Zoom curve mode setting

This item makes it possible to change the zoom speed characteristics which is established in response to the amount
by which the analog demand is titled. (Bear in mind that the display is switched to another screen when these
characteristics are set.)
IMPORTANT:
Top initial screen
[ ] 1
Menu
[ IND ] I G :
VTR
A 1 V
FRM1 RET
A 2 R
Screen A
[ ] 1
Menu
FRM1 RET
A 2 R
[ Z.M. ] [Trk]OFF
[CAFS] ON Auto
CurveMode screen
[ ]
Zoom
CurveMode
Demand: 5
[ ]
Zoom
CurveMode
Demand:
D5
[ ]
Zoom
CurveMode
Demand: 8
1
Selection item
[ IND ]
E3-10
3. Top screen – Zoom curve mode setting
Prior to operation, select the user for whom the settings will be made.
(For details on how to select the user, refer to page E3-4 or E4-4.)
5 0
1. Push the
The item is now highlighted.
2. Push the
The display is switched to the
CurveMode screen.
3. Push the
An underline appears below [Demand].
The last setting or default value is highlighted.
4. Push the
Push the left or right key until the number
to be changed to appears.
5. Push the
The display returns to Screen A.
2 3
x3
[ Z.M. ]
Set
key three times.
key.
Set
key.
key or key.
key.
Set
4 D5
(D): Default value
x2 or
Amount of change resulting from
zoom mode adjustment
MAX
Amount by which analog demand is pushed in
Zoom direction
Wide angle
MAX
6 7
(A) Adjustable amount by the Zoom Mode
Adjusting Trimmer
or Set
Amount That the Zoom Seesaw Switch is Pressed Down
Zooming direction
Wide
(9)
(1)
Telephoto
8 9
Telephoto