Setting F-Hold To On Or Off - Canon XJ22 7.3B Series Operator's Manual

Setting F-Hold to ON or OFF

F-Hold can be set to ON or OFF.
The same F-Hold setting can be used for all the users regardless of the user who is indicated on the display. For this
reason, there is no need to select the user before performing the setting. As an exception to the general rule, any
change made in the setting is reflected for user 0 as well.
Top initial screen
[ ] 1
Menu
[ IND ] I G : 5 0
EXT VTR
A 1 V
FRM1 RET
A 2 R
Zoom screen
[ ]
Zoom
Tracking: OFF
F-Hold: OFF
Movement
[ ]
Zoom
Tracking OFF
F-Hold: OFF OFF
Movement
[ ]
Zoom
Tracking OFF
F-Hold: ON ON
Movement
※ (NOTE): The F-Hold setting is not initialized even when the steps described in "Initializing" on page E4-6 are
taken.
The F-Hold setting is not stored in the memory when the power is turned off. When the power is
turned on again, {OFF} is established as the default setting.
When Iris is set as Auto, F-Hold can not be set {ON}.
(D)
Selection item
OFF
Function F-Hold disabled
(D): Default value
Menu
1. Push the
The display is switched to the Zoom screen.
2. Push the
An underline appears below [F-Hold].
The function set last or default function is
highlighted.
3. Push the
Push the left or right key to set the function to {ON}
or {OFF}.
ON
F-Hold enabled
Set x4 Zoom
key, push the key and push the
Set
key twice.
key or key.
[ ]
x2
Zoom – Setting F-Hold to ON or OFF
4. Menu screen – Zoom
key four times.
or
E4-45