Unify OpenStage 10 T Administration Manual page 21

Administration
OpenStage 60/80
If a parameter is set by entering a number or character data, the onscreen keypad is used. Press
the
for selecting numbers, characters, or groups of characters. The h key deletes one character in
the input field, and the g key moves the cursor to the OK field.
The following figure describes the elements of the onscreen keypad and their functions:
Additionally, you can use the following keys on the keypad as shortcuts for the selection of char-
acter groups
Element
*
#
OpenStage 15/20/30/40
With the OpenStage 15/20/30/40, use the keypad for entering parameters. With the 3 way/5 way
navigator, you can enter, delete, copy and paste characters and numbers as well as navigate
within an entry and toggle the input mode.
6. Save and exit
When you are done, select Save & exit and press
i
key to enter the editor. Within the editor, solely use the key numbers or the Sensor Wheel
Function
Switch to punctuation and special characters.
Toggle between lowercase characters, uppercase characters, and digits.
Element with focus
Letters, digits, punctuation marks or special characters
Command line
Copy contents of active field to clipboard
Insert clipboard contents at cursor position
Move cursor left/right
Shift to punctuation and special characters
Shift to numeric entry
Shift to upper/lower case
.
21