About The Electronic Keyer Function; Auto Tuning Function; Cw Mode - Icom IC-705 Basic Manual

4
RECEIVING AND TRANSMITTING
Operating CW
DAbout the electronic Keyer function
You can set the Memory Keyer function
settings, paddle polarity settings, and so on of
the Electronic Keyer.
1. Select the CW mode.
2. Open the KEYER screen.
» KEYER
3. Touch [EDIT/SET].
• Opens the EDIT/SET screen.
4. Select the desired item to set.
5. To close the KEYER screen, push
several times.

Auto Tuning function

CW mode

You can tune in a CW signal you are receiving
using the Auto Tuning function. You can
automatically tune by pushing
function is active only in the CW mode.
LWhile using the RIT function, the RIT frequency is
automatically tuned by this function.
NOTE: When receiving a weak signal, or
receiving a signal with interference, the Auto
Tuning function may tune the receiver to an
undesired signal, or may not start to tune. In
such case, a warning beep sounds.
LThe Auto Tuning function tunes the frequency in
the IF bandwidth.
EDIT
001 SET
CW-KEY SET
. This
4-13
KEYER MEMORY edit menu
You can edit the Keyer memories
M1 to M8.
KEYER 001 Contest Number menu
You can set the following items.
• Number Style
• Count Up Trigger
• Present Number
CW-KEY SET menu
You can set the following items.
• Side Tone Level
• Side Tone Level Limit
• Keyer Repeat Time
• Dot/Dash Ratio
• Rise Time
• Paddle Polarity
• Key Type
• MIC Up/Down Keyer
Displayed
while tuning