Troubleshooting - Yardworks 060-1300-6 Instruction Manual

model no.
060-1300-6
PRObleM
Engine does not
start
Engine runs
poorly
Engine overheats
Engine does not
shut off
Wheels and tines
will not turn
Tines turn, but
wheels don't
| contact us: 1.866.523.5218
POssIble CAUse
Spark plug wire disconnected.
Engine Throttle Control Lever incorrectly
set.
Fuel tank empty.
Choke control (if so equipped) in incorrect
position.
Stale gasoline.
Dirty air filter.
Defective or incorrectly gapped spark plug.
Carburetor out of adjustment.
Misadjusted throttle control.
Dirt or water in fuel tank.
Defective or incorrectly gapped spark plug.
Dirty air filter(s).
Carburetor out of adjustment.
Stale gasoline.
Dirt or water in fuel tank.
Engine cooling system clogged.
Engine cooling system clogged.
Carburetor out of adjustment.
Oil level is low.
Misadjusted throttle control or ignition
switch.
Improper use of controls.
Worn, broken, or misadjusted drive belt(s).
Internal transmission wear or damage.
Bolt loose in transmission pulley.
Wheel Drive Pins not in WHEEL DRIVE.
Bolt loose in transmission pulley.
Internal transmission wear or damage.
sOlUTION
Reconnect wire.
Put lever in START position.
Add fuel.
Move to CHOKE position.
Drain fuel and add fresh fuel.
Clean or replace filter.
Inspect spark plug.
Contact Technical Support Team.
Contact Technical Support Team.
Contact Technical Support Team.
Inspect spark plug.
Clean or replace.
Contact Technical Support Team.
Replace with fresh gasoline.
Contact Technical Support Team.
Clean air cooling system .
Clean air cooling area.
Contact Technical Support Team.
Check oil level.
Contact Technical Support Team.
Review controls section.
See "Checking and Adjusting
Forward Drive Belt Tension" or "Belt
Tension Adjustment".
Contact local dealer or the factory.
Tighten bolt.
See "Wheel Drive Pins".
Tighten bolt.
Contact Technical Support Team.
79