To Change The Engine Oil - Yardworks 060-1300-6 Instruction Manual

model no.
060-1300-6
B. To Change the Engine Oil:
1. Place tiller on a flat, level surface.
2. Put the wheels in the WHEEL DRIVE
position.
3. Remove the left-side wheel and
carefully prop up until ready to drain
the engine oil.
4. Tilt the left-side wheel shaft into a drain
pan.
5. Clean around the oil drain plug to
prevent dirt from falling into the
crankcase. Remove oil drain plug.
6. Allow the engine oil to drain.
7. Replace oil drain bolt.
8. Reinstall the wheel.
9. Refill the with engine oil through the
dipstick with funnel and replenish the
fuel tank with gasoline.
 CAUTION: DO NOT attempt to crank or start the engine before it
has been properly filled with the recommended type and amount of oil.
Damage to the tiller as a result of failure to follow these instructions will
void your warranty.
NOTICe: The recommended oil type is 10W-30 automotive oil.

NOTICe: Check oil often during the break-in period. Refer to the

Maintenance section for recommended service intervals.
CAUTION: The engine is equipped with a low oil shut-off and will

stop when the oil level in the crankcase falls below the threshold level.
| contact us: 1.866.523.5218
57
DRAIN BOLT