Replacement Belt Information; Spring Adjustment - Yardworks 060-1300-6 Instruction Manual

model no.
060-1300-6
5. To adjust the length of the spring:
5a. Release the forward lever.
5b. Un-thread the hex nut halfway up the adjustment screw.
5c. Unhook the top of the spring from the lever.
5d. Use pliers to prevent the adjuster from turning, and turn the slotted screw located
inside the spring clockwise (viewed from operator's position) to increase tension on
the spring. Turn the screw counter-clockwise to decrease tension. Once adjusted,
reattach the spring to the lever.
5e. Repeat Steps 2 and 3 to re-measure the length of the spring. When the second
measurement is between 1⁄16 to 3⁄16" (2 to 5 mm) shorter than the first measurement,
re-tighten the hex nut against the top of the adjuster.

Spring Adjustment

RePlACeMeNT belT INfORMATION

If the drive belt needs to be replaced, refer to the parts list for information. The procedure
requires average mechanical ability and commonly available tools to change or replace.
length (inches)
7PK612 24" ± 0.24"
5PK730 29" ± 0.20"
| contact us: 1.866.523.5218
Width (inches)
0.95" ±0.01"
0.70" ±0.02"
INCREASE DECREASE
TENSION TENSION
OPEN LENGTH - CLOSED LENGTH = 1/16 to 3/16" (2 to 5 mm)
length (mm)
7PK612 612.0 ± 6.0 mm
5PK730 730.0 ± 5.0 mm
49
Width (mm)
24.20 ± 0.30 mm
17.80 ± 0.50 mm