Depth Regulator Lever Adjustment - Yardworks 060-1300-6 Instruction Manual

model no.
060-1300-6

DePTH ReGUlATOR leVeR ADJUsTMeNT

This regulator lever controls the tilling depth of the tines. Remove pin and clip and slide
regulator lever up or down as required. Reassemble pin and clip.
The "travel position" (highest hole) raises the tines approximately 11⁄2" off the ground,
allowing the tiller to be moved without the tines contacting the ground. This setting should
also be used when starting the engine.
Moving the regulator lever upward will increase the tilling depth. The lowest notch allows
a tilling depth of approximately 6" (15 cm), depending on soil conditions. For best results,
always begin tilling at a very shallow depth setting and gradually increase the tilling depth.
WARNING: Do not attempt to till too deeply too quickly.

Gradually work down to deeper tilling depths.
Place the Depth Regulator Lever in the "travel" position before starting
the engine. This position prevents the tines from touching the ground
until you are ready to begin tilling.
Failure to follow this warning could result in personal injury or property
damage.
| contact us: 1.866.523.5218
27