Freewheel Position - Yardworks 060-1300-6 Instruction Manual

model no.
060-1300-6
FOR WHEEL DRIVE MODE: Slide wheel
outward and align the holes. Insert locking
pin through wheel hub and wheel shaft.
Secure wheel locking pin by pushing in as
far as it will go then wrapping ring around
the wheel shaft as shown. Repeat with the
other wheel and then remove the support
from beneath the transmission.

Freewheel Position

 WARNING: Before starting engine, be sure that both wheels are in
WHEEL DRIVE position. See Wheel Drive Pins for instructions.
Engaging the Forward Lever when the wheels are not in WHEEL DRIVE
could allow the tines to rapidly propel the tiller forward or backward.
Failure to comply could cause loss of tiller control, property damage, or
personal injury.
| contact us: 1.866.523.5218
Wheel Drive Position
FOR FREEWHEEL MODE: Slide the wheel
inward and insert the wheel drive locking
pin only through the hole in the axle shaft.
Secure wheel locking pin by pushing in as
far as it will go then wrapping ring around
the wheel shaft as shown. Repeat for the
other wheel and then remove the support
from beneath the transmission.
25