Check Hardware; Check Tire Pressure; Transmission Gear Oil Service - Yardworks 060-1300-6 Instruction Manual

44
model no.
060-1300-6

CHeCK HARDWARe

Check for loose or missing hardware after every 10 operating hours and tighten or
–
replace (as needed) before reusing tiller.
Be sure to check the screws underneath the tiller hood that secure the transmission
–
cover and the Depth Regulator Lever to the transmission.

CHeCK TIRe PRessURe

(Models with pneumatic tires) Check the air pressure in both tires. The air pressure
–
should be between 15 PSI and 20 PSI (pounds per square inch).
Keep both tires equally inflated to help prevent machine from pulling to one side.
–

TRANsMIssION GeAR OIl seRVICe

Check the transmission gear oil level after
every 30 hours of operation or whenever
you notice any oil leak. Operating the tiller
when the transmission is low on oil can
result in severe damage.
A. To Check the Transmission Gear Oil
Level:
1. Check the gear oil level when
the transmission is cool. Gear oil
will expand in warm operating
temperatures and this expansion will
provide an incorrect oil level reading.
2. With the tiller on level ground, pull the
Depth Regulator Lever all the way up.
3. Remove the dipstick/oil fill plug from
the transmission housing and look
inside the oil fill hole to locate the main
drive shaft situated below the hole.
4. The gear oil level is correct if it falls
between the L and H marks on th oil
dipstick.
| contact us: 1.866.523.5218
MAX
MIN
DIPSTICK