Troubleshooting - Yardworks TC70020-1 Owner's Manual

Store the Tiller/Cultivator in a dry, clean area out of reach of
children.
During extended periods of storage, ensure that the tiller/
cultivator is protected against corrosion and rust.
Problem Possible Couse
-Unit does not Run -Battery not making contact
-Trigger switch not operational
-Battery not installed properly
-Battery not charged
Abnormal noises
-Tine is jammed.
-Bolts, nuts or other components are loose.
-Tines damaged or worn
Abnormal vibrations
-Working depth too large
-Battery will not charge -Battery not inserted into charger
-Charger not plugged in
-Surrounding air temperature too hot or too cold -Move charger and tool to a surrounding air temperature of about 39
Working depth too small
Poor results
Worn tines
For parts or service, please call 1-800-633-1501 or visit us online at www.americanlawnmower.com. Be
sure to provide all relevant information when you call or visit.
REPAIR PARTS (KITS/ ITEMS)
The model number of this tool is found on a plate or label attached to the housing. Please record the serial
number in the space provided below.
MODEL NUMBER
SERIAL NUMBER_______________
Always mention the model number when ordering kits/items for this tool.

TROUBLESHOOTING

TC70020-1_____
No. Kit/ Item Number
1 RTC70020/25-FHK
2 RTC70020/25-TK-1
3 BL82120-1
4 CHL82000-1
Call us first with questions about operating or maintaining your product
at 1-800-633-1501 between 8:00 a.m. – 5:00 p.m. Eastern Standard Time,
or get assistance on www.americanlawnmower.com.
STORAGE
At the end of the season, or if the tiller/cultivator is not being
used for longer than a month, wipe over all metal surfaces
with an oil soaked cloth to protect them from corrosion or
spray with a fine coat of oil.
Do not expose to rain. Store indoors.
Possible Solution
-Check battery is fully inserted
-Check that lock off button is fully depressed prior to moving trigger
-Check battery installation
-Check battery charging requirements
-Switch off. Wait till tines comes to a complete stop. Remove jammed
objects.
-Tighten all components. Arrange for repair if noises continue.
-Replace damaged or worn tines.
-Adjust working depth.
-Insert battery into charger until red LED appears
-Plug charger into a working outlet
-Check current at receptacle by plugging in a lamp or other appliance
-Check to see if receptacle is connected to a light switch which turns
power off when you turn out the lights
degree F (4 degree C) or below 104 degree F (+40 degree c)
Adjust working depth.
Replace damaged or worn tines.
Description
Front Handle Kit
Tine Kit
Battery Pack
Charger
CALL US FIRST !!
9
Model TC70020-1
QTY
1
1
1
1