When Adding Or Removing Gasoline; When Storing The Tiller - Yardworks 060-1300-6 Instruction Manual

model no.
060-1300-6

When adding or removing gasoline:

Turn the tiller off and let it cool for at
–
least two minutes before removing the
gasoline cap. Loosen the cap slowly to
relieve pressure in the tank.
DO NOT light or smoke cigarettes
–
when handling gasoline.
Only fill or drain gasoline outdoors in a
–
well-ventilated area.
DO NOT pump gasoline directly into
–
the tiller at the gas station. Use an
approved fuel container to transfer the
fuel to the tiller.
DO NOT overfill the gasoline tank.
–
ALWAYS keep gasoline away from
–
sparks, open flames, pilot lights, heat
and other sources of ignition.
When starting the tiller:
DO NOT attempt to start a damaged
–
tiller.
Make certain that the gasoline cap, air
–
filter, spark plug, fuel lines and exhaust
system are properly in place.
 DANGeR: GASOLINE AND GASOLINE VAPOURS ARE HIGHLY
FLAMMABLE AND EXPLOSIVE.
Fire or explosion can cause severe burns or death.
WARNING: Handle fuel with care; it is highly flammable and its

vapours are explosive
| contact us: 1.866.523.5218
Allow spilled gasoline to evaporate
–
fully before attempting to start the
engine.
Make certain that the tiller is resting
–
firmly on level ground.
When operating the tiller:
DO NOT tip the tiller or allow fuel or oil
–
to spill.
When transporting or servicing the
tiller:
Make certain that the fuel valve is in
–
the OFF position, and the gasoline
tank is empty.
Disconnect the spark plug wire.
–

When storing the tiller:

Store away from sparks, open flames,
–
pilot lights, heat and other sources of
ignition.
Do not store tiller or gasoline near
–
furnaces, water heaters, or any other
appliances that produce heat or have
automatic ignitions.
7