Configuring A Wep Key - Cisco 7920 Administration Manual

Entering or Verifying Wireless Settings
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6

Configuring a WEP Key

Step 1
Step 2
Step 3
Step 4
Cisco Wireless IP Phone 7920 Administration Guide for Cisco CallManager Release 3.3 or Later
6-8
Chapter 6 Configuring the Wireless Network Settings on the Cisco Wireless IP Phone 7920
Procedure
Press the Menu softkey.
Choose Network Config > 802.11b Configuration > Wireless Settings
Scroll to Encryption and press Select.
The WEP Key options display.
Scroll to the WEP key that you want to activate, and press Select.
Scroll to Activate and press OK to activate the key.
A check mark appears next to the activated key.
Press Back to return to the Wireless Setting options.
After you activate a WEP key you need to configure the password. You can choose
on of the following types of encryption schemes:
• 40-bit encryption—You must enter a 10-digit password that uses the
hexadecimal format of 0-9 and/or the characters A-F (for example,
ABCD123456).
128-bit encryption—You must enter a 26-digit password that uses the
•
hexadecimal format of 0-9 and/or the characters A-F (for example,
AB123456789CD01234567890EF).
• None—The WEP key function is disabled.
To configure the WEP passwords, use the following steps.
Procedure
Press the Menu softkey.
Choose Network Config > 802.11b Configuration > Wireless Settings
Scroll to Encryption and press Select.
The WEP Key options display.
Scroll to the WEP key that you activated, and press Select.
OL-3930-02