Setting The Cisco Light Extensible Authentication Protocol (Leap); Setting The Leap Username - Cisco 7920 Administration Manual

Entering or Verifying 802.11b Configuration Settings
Step 4
Step 5

Setting the Cisco Light Extensible Authentication Protocol (LEAP)

Setting the LEAP Username

Step 1
Step 2
Step 3
Step 4
Step 5
Cisco Wireless IP Phone 7920 Administration Guide for Cisco CallManager Release 3.3 or Later
6-12
Chapter 6 Configuring the Wireless Network Settings on the Cisco Wireless IP Phone 7920
Press Select to view the network type.
Press Back to return to the 802.11b Configuration menu options.
Related Topics
Viewing the Associated Access Point MAC Address, page 6-10
•
Viewing the Associated AP SSID, page 6-11
•
• Setting the Cisco Light Extensible Authentication Protocol (LEAP),
page 6-12
When your network uses Cisco LEAP for user authentication and voice
encryption, you must configure both the user name and a password on the access
control server (ACS) and the phone.
Use the following steps to set up the LEAP requirements on the phone.
To to enter or change the LEAP username, you must use exactly the same
username in the phone option that is configured in the ACS server.
The maximum length of the LEAP username entry is 32 characters.
Note
Procedure
Press the Menu softkey.
Choose Network Config > 802.11b Configuration
Scroll to LEAP and press Select.
The LEAP options display.
Scroll to Username and press Select.
Press the Edit softkey.
OL-3930-02